Log In Cart
Your Shopping Cart Is Empty
Free Shipping On Orders Over $99*
Search By Vehicle
75-5140

Cold Air Intake for 2020-2022 Ford Powerstroke 6.7L

USD
Airflow Improvement
segmented-bar graphic icon +0.00%
Efficiency Rating
segmented-bar graphic icon 0.00%
Choose a filter type:
Free Shipping On Orders Over $99
Get it by ,
If ordered within hours and minutes
Not Shipping to ?
Install Instructions Test Results Install Video
Warning Icon TrianglePROP 65 WARNING
WARNING

Filter Type Cotton or Dry
Street Legal In All US States Pending
Year Make Model Engine
2020 Ford F-250 6.7L, Diesel
2020 Ford F-350 6.7L, Diesel
2021 Ford F-250 6.7L, Diesel
2021 Ford F-350 6.7L, Diesel
2022 Ford F-250 6.7L, Diesel
2022 Ford F-350 6.7L, Diesel

Overview

Maximum Performance

Our cold air intake for the 2020-2022 Ford 6.7L Powerstroke was engineered to minimize air restriction and flow better than stock. This kit comes with a fully enclosed airbox that protects the filter from dirt and keeps out engine heat.

New Snap In Lid Design

Our new snap-In lid design requires no screws to secure it to the box. This makes installation and inspection quick and easy, as the filter can be installed and removed without having to remove the intake tube. Our silicone edge trim provides a protective seal against unwanted, power-robbing engine heat and debris. This kit comes with a massive, highly-efficient air filter which results in better performance and protects your engine. Available in either 8-layer Cotton Cleanable or Dry Extendable media. (Patent Pending)

LESS RESTRICTION.
MORE AIRFLOW.

The Intake Tube has minimal bends as it connects to the turbo inlet. It is positioned in one clean line with minimum obstructions from the turbo inlet to the intake box and air filter. This results in a decrease in restriction compared to stock.

Choose your airflow.

The 75-5140 intake kit has (2) airflow configurations. S&B includes a silicone box plug that can be installed or removed depending on personal preference and airflow requirements. 

Silicone Box Plug removed: This configuration will provide an extra air inlet that will be pulled from the passenger side fender area. 

Silicone Box Plug installed: This configuration will seal the secondary air inlet located on the side of the box facing the vehicle fender. The front-facing grill inlet and the front scoop will become the main source of airflow into the Intake Box.

No Check Engine Lights

S&B devotes a huge amount of resources to engineer our intakes that allow your engine to run properly with stock calibration or enhanced tuning. An injection molded MAF plate in conjunction with a foam MAF sensor gasket ensures a true OE seal to the sensor.


back to top button